medium grind · 500-800 microns
Breville Smart Grinder Pro grind setting for drip machine
Start at 52 on the Breville Smart Grinder Pro for drip machine, and stay inside 49-54. Brew at 1:16 for 4-6 min.
For paper filters. Breville lists gold-tone filters at 31-48.
- Ratio
- 1:16
- Time
- 4-6 min
- Water
- machine set
Taste, then fix
If it tastes wrong
| It tastes | Why | Do this on the Smart Grinder Pro |
|---|---|---|
| Sour, thin, sharp | Under-extracted: water ran through too fast | Go 1 to 2 steps finer so the drawdown slows |
| Bitter, dry, astringent | Over-extracted or the bed choked | Go 1 to 2 steps coarser so the drawdown speeds up |
| Drawdown far past target time | Grind too fine or too many fines | Go 2 steps coarser; check the burrs are clean |
| Weak but balanced | Too little coffee for the water | Tighten the ratio half a step, e.g. 1:16 to 1:15.5 |
What you are aiming for
Flat-bottom drip baskets like a medium grind, close to coarse sand. Use the ratio, not the scoop marks on the carafe.
On the Breville Smart Grinder Pro, 52 is the documented start. If your grounds look much finer or coarser than this, your grinder may be calibrated differently: trust the taste, then the number.
Fix the beans too
Better drip machine starts with fresher beans.
The right grind only gets out what the beans have. A subscription keeps fresh coffee arriving before you run out.
We may earn a commission if you buy through these links. It never changes the settings we publish.
More Breville Smart Grinder Pro settings
Drip coffee maker on other grinders
Questions
What grind setting should I use on the Breville Smart Grinder Pro for drip machine?
Start at 52 on the Breville Smart Grinder Pro for drip machine, and stay inside 49-54. Brew at 1:16 for 4-6 min.
My drip machine tastes sour on the Breville Smart Grinder Pro. What do I change?
Sour means under-extracted. Go 1 to 2 steps finer so the drawdown slows. Change one thing at a time and taste again.
My drip machine tastes bitter on the Breville Smart Grinder Pro. What do I change?
Bitter means over-extracted. Go 1 to 2 steps coarser so the drawdown speeds up.
Source
assets.breville.com. Settings are starting points; two grinders of the same model can sit a step or two apart.