Skip to content

medium grind · 500-800 microns

Baratza Sette 270 grind setting for drip machine

Start at 20 on the Baratza Sette 270 for drip machine, and stay inside 15-25. Brew at 1:16 for 4-6 min.

Baratza gives no single start point. 20 is the middle of its range.

FINECOARSE
20range 15-25
Ratio
1:16
Time
4-6 min
Water
machine set

Taste, then fix

If it tastes wrong

It tastesWhyDo this on the Sette 270
Sour, thin, sharpUnder-extracted: water ran through too fastGo 1 to 2 steps finer so the drawdown slows
Bitter, dry, astringentOver-extracted or the bed chokedGo 1 to 2 steps coarser so the drawdown speeds up
Drawdown far past target timeGrind too fine or too many finesGo 2 steps coarser; check the burrs are clean
Weak but balancedToo little coffee for the waterTighten the ratio half a step, e.g. 1:16 to 1:15.5
What a medium grind for drip machine looks like
What medium looks like

What you are aiming for

Flat-bottom drip baskets like a medium grind, close to coarse sand. Use the ratio, not the scoop marks on the carafe.

On the Baratza Sette 270, 20 is the documented start. If your grounds look much finer or coarser than this, your grinder may be calibrated differently: trust the taste, then the number.

Fix the beans too

Better drip machine starts with fresher beans.

The right grind only gets out what the beans have. A subscription keeps fresh coffee arriving before you run out.

We may earn a commission if you buy through these links. It never changes the settings we publish.

More Baratza Sette 270 settings

Questions

What grind setting should I use on the Baratza Sette 270 for drip machine?

Start at 20 on the Baratza Sette 270 for drip machine, and stay inside 15-25. Brew at 1:16 for 4-6 min.

My drip machine tastes sour on the Baratza Sette 270. What do I change?

Sour means under-extracted. Go 1 to 2 steps finer so the drawdown slows. Change one thing at a time and taste again.

My drip machine tastes bitter on the Baratza Sette 270. What do I change?

Bitter means over-extracted. Go 1 to 2 steps coarser so the drawdown speeds up.

Source

assets.breville.com, baratza.com. Settings are starting points; two grinders of the same model can sit a step or two apart.