medium-fine grind · 320-960 microns
1Zpresso Q2 grind setting for AeroPress
Start at 1.6.0 on the 1Zpresso Q2 for AeroPress, and stay inside 1.2.0-2.0.0. Brew at 1:15 for 1:30-2:30.
- Ratio
- 1:15
- Time
- 1:30-2:30
- Water
- 85-95 C
Taste, then fix
If it tastes wrong
| It tastes | Why | Do this on the Q2 |
|---|---|---|
| Sour, thin, sharp | Under-extracted: grind too coarse or steep too short | Go 2 to 3 steps finer, or add 30 to 60 seconds of steep time |
| Bitter, dry, harsh finish | Over-extracted: grind too fine or steep too long | Go 2 to 3 steps coarser, or cut 30 seconds of steep time |
| Hard to press | Grind too fine | Go 2 steps coarser; the press should take about 30 seconds of gentle pressure |
| Weak but not sour | Not enough coffee for the water | Tighten the ratio: use 1 to 2 more grams per 250 g of water |
What you are aiming for
The AeroPress is forgiving and works across a wide grind range. Finer grinds pair with shorter steeps, coarser grinds with longer ones.
On the 1Zpresso Q2, 1.6.0 is the documented start. If your grounds look much finer or coarser than this, your grinder may be calibrated differently: trust the taste, then the number.
Fix the beans too
Better AeroPress starts with fresher beans.
The right grind only gets out what the beans have. A subscription keeps fresh coffee arriving before you run out.
We may earn a commission if you buy through these links. It never changes the settings we publish.
More 1Zpresso Q2 settings
Questions
What grind setting should I use on the 1Zpresso Q2 for AeroPress?
Start at 1.6.0 on the 1Zpresso Q2 for AeroPress, and stay inside 1.2.0-2.0.0. Brew at 1:15 for 1:30-2:30.
My AeroPress tastes sour on the 1Zpresso Q2. What do I change?
Sour means under-extracted. Go 2 to 3 steps finer, or add 30 to 60 seconds of steep time. Change one thing at a time and taste again.
My AeroPress tastes bitter on the 1Zpresso Q2. What do I change?
Bitter means over-extracted. Go 2 to 3 steps coarser, or cut 30 seconds of steep time.
Source
1zpresso.coffee, 1zpresso.coffee. Settings are starting points; two grinders of the same model can sit a step or two apart.