medium grind · 500-800 microns
Fellow Ode Gen 2 grind setting for drip machine
Start at 8 on the Fellow Ode Gen 2 for drip machine, and stay inside 7-9. Brew at 1:16 for 4-6 min.
Fellow calls this 'Electric Coffee Maker'.
- Ratio
- 1:16
- Time
- 4-6 min
- Water
- machine set
Taste, then fix
If it tastes wrong
| It tastes | Why | Do this on the Ode Gen 2 |
|---|---|---|
| Sour, thin, sharp | Under-extracted: water ran through too fast | Go 1 to 2 steps finer so the drawdown slows |
| Bitter, dry, astringent | Over-extracted or the bed choked | Go 1 to 2 steps coarser so the drawdown speeds up |
| Drawdown far past target time | Grind too fine or too many fines | Go 2 steps coarser; check the burrs are clean |
| Weak but balanced | Too little coffee for the water | Tighten the ratio half a step, e.g. 1:16 to 1:15.5 |
What you are aiming for
Flat-bottom drip baskets like a medium grind, close to coarse sand. Use the ratio, not the scoop marks on the carafe.
On the Fellow Ode Gen 2, 8 is the documented start. If your grounds look much finer or coarser than this, your grinder may be calibrated differently: trust the taste, then the number.
Fix the beans too
Better drip machine starts with fresher beans.
The right grind only gets out what the beans have. A subscription keeps fresh coffee arriving before you run out.
We may earn a commission if you buy through these links. It never changes the settings we publish.
More Fellow Ode Gen 2 settings
Drip coffee maker on other grinders
Questions
What grind setting should I use on the Fellow Ode Gen 2 for drip machine?
Start at 8 on the Fellow Ode Gen 2 for drip machine, and stay inside 7-9. Brew at 1:16 for 4-6 min.
My drip machine tastes sour on the Fellow Ode Gen 2. What do I change?
Sour means under-extracted. Go 1 to 2 steps finer so the drawdown slows. Change one thing at a time and taste again.
My drip machine tastes bitter on the Fellow Ode Gen 2. What do I change?
Bitter means over-extracted. Go 1 to 2 steps coarser so the drawdown speeds up.
Source
help.fellowproducts.com, fellowproducts.com. Settings are starting points; two grinders of the same model can sit a step or two apart.