Skip to content

extra coarse grind · 800-1500 microns

OXO Brew Conical Burr Grinder grind setting for cold brew

Start at 13 on the OXO Brew Conical Burr Grinder for cold brew, and stay inside 11-15. Brew at 1:8 for 12-18 h.

OXO's French press/cold brew band.

FINECOARSE
13range 11-15
Ratio
1:8
Time
12-18 h
Water
fridge or room temp

Taste, then fix

If it tastes wrong

It tastesWhyDo this on the Brew Conical Burr Grinder
Bitter, woodyGrind too fine or steeped too longGo coarser or cut the steep to 12 hours
Weak, tea-likeToo little coffee or too short a steepUse a 1:7 concentrate or steep to 16-18 hours
Cloudy, grittyFines passing the filterGo coarser and filter a second time through paper
What a extra coarse grind for cold brew looks like
What extra coarse looks like

What you are aiming for

Cold brew steeps for hours, so it takes the coarsest grind your grinder makes. Dilute the concentrate about 1:1 to serve.

On the OXO Brew Conical Burr Grinder, 13 is the documented start. If your grounds look much finer or coarser than this, your grinder may be calibrated differently: trust the taste, then the number.

Fix the beans too

Better cold brew starts with fresher beans.

The right grind only gets out what the beans have. A subscription keeps fresh coffee arriving before you run out.

We may earn a commission if you buy through these links. It never changes the settings we publish.

More OXO Brew Conical Burr Grinder settings

Questions

What grind setting should I use on the OXO Brew Conical Burr Grinder for cold brew?

Start at 13 on the OXO Brew Conical Burr Grinder for cold brew, and stay inside 11-15. Brew at 1:8 for 12-18 h.

My cold brew tastes sour on the OXO Brew Conical Burr Grinder. What do I change?

Sour means under-extracted. Go coarser or cut the steep to 12 hours. Change one thing at a time and taste again.

My cold brew tastes bitter on the OXO Brew Conical Burr Grinder. What do I change?

Bitter means over-extracted. Use a 1:7 concentrate or steep to 16-18 hours.

Source

oxo.com. Settings are starting points; two grinders of the same model can sit a step or two apart.